<![CDATA[Unix static agent build fails]]>Hello Victor,

I'm configuring netxms on CentOS 6.2 with following ./configure --with-agent-static. Configure script executes normally. But make produces error:

../../../tools/create_ssa_list.sh "linux ecs logwatch ping portcheck ups" > static_subagents.cpp
  CXX    static_subagents.o
  CXX    subagent.o
  CXX    sysinfo.o
  CXX    tools.o
  CXX    trap.o
  CXX    upgrade.o
  CXX    watchdog.o
make[4]: *** No rule to make target `../../../src/db/libnxdb/libnxdb.la', needed by `nxagentd'.  Stop.
make[4]: Leaving directory `/distr/netxms-1.2.1/src/agent/core'
make[3]: *** [all-recursive] Error 1
make[3]: Leaving directory `/distr/netxms-1.2.1/src/agent'
make[2]: *** [all-recursive] Error 1
make[2]: Leaving directory `/distr/netxms-1.2.1/src'
make[1]: *** [all-recursive] Error 1
make[1]: Leaving directory `/distr/netxms-1.2.1'
make: *** [all] Error 2
[root@netxms netxms-1.2.1]#

Can that be fixed?

]]>https://forum.netxms.org/topic/1772/unix-static-agent-build-failsRSS for NodeFri, 13 Nov 2026 09:55:39 GMTWed, 13 Jun 2012 09:33:49 GMT60<![CDATA[Reply to Unix static agent build fails on Wed, 20 Jun 2012 12:35:22 GMT]]>KjellO, this also worked for me!
The trick is that all subsequent "makes" are successful, even if I make global "make clean" before configuring with different parameters.
Thanks a lot!

]]>https://forum.netxms.org/post/7694https://forum.netxms.org/post/7694Wed, 20 Jun 2012 12:35:22 GMT<![CDATA[Reply to Unix static agent build fails on Fri, 15 Jun 2012 20:11:18 GMT]]>Hi!
I finally managed to build a static 1.2.1 agent, I did something like this:

$ ./configure --with-static-agent --with-all-static --with-static-subagents="" --with-internal-libexpat --with-internal-libtre --with-internal-zlib --prefix=/some/targetdir
$ make

Will complain, No target to build libnxdb exactly as you describe.
Build this by hand:

$ cd src/db/libnxdb/
$ make

Then try a build from source root again.
I then run into trouble when making nxpush, but that may be distribution specific (old debian).
Anyway, I disabled nxpush (don't need it)

$ <your favorite editor> src/agent/tools/Makefile

change
SUBDIRS = nxapush

to
SUBDIRS =

Then a make from source root dir should work.

Good luck!

]]>https://forum.netxms.org/post/7662https://forum.netxms.org/post/7662Fri, 15 Jun 2012 20:11:18 GMT<![CDATA[Reply to Unix static agent build fails on Wed, 13 Jun 2012 09:43:48 GMT]]>There was the same error for 1.2.0 version according to forum. It persists in 1.2.1.  😞

]]>https://forum.netxms.org/post/7654https://forum.netxms.org/post/7654Wed, 13 Jun 2012 09:43:48 GMT