<![CDATA[CISCO SMB Switch driver]]>would it be possible to develop a driver for cisco SMB (Small Business series 200, 300. 500) switches. I have customers using cisco smb switches. They are managable support LLDP, CDP, SNMP, STP.
Which information you would need for that?

]]>https://forum.netxms.org/topic/2856/cisco-smb-switch-driverRSS for NodeFri, 13 Nov 2026 14:50:06 GMTFri, 17 Jan 2014 13:16:44 GMT60<![CDATA[Reply to CISCO SMB Switch driver on Fri, 17 Jan 2014 15:52:16 GMT]]>So basically almost everything is working. CDP may be empty if nobody in the network sends CDP packets except that switch.

Yes, you can send dump by mail.

Best regards,
Victor

]]>https://forum.netxms.org/post/12492https://forum.netxms.org/post/12492Fri, 17 Jan 2014 15:52:16 GMT<![CDATA[Reply to CISCO SMB Switch driver on Fri, 17 Jan 2014 15:29:34 GMT]]>Ok I short list what I get at the moment from such a switch (Cisco SG300):
'Show VLANs': ok
'Layer2 Topology': empty (only Switch itself)
Tools - Info - Topology Table (CDP): empty
Tools - Info - Topology Table (LLDP): empty
Tools - Info - Switch forwarding database: ok
Object Details - Ports: empty
Object Details - Interfaces: ok
Capabilities: isBridge, isCDP, isLLDP, isSNMP, isSTP, hasEntityMIB, hasifXTable
Poll - Topology:
    VLAN list successfully retrieved from node
    Switch forwarding database retrieved
    Link layer topology retrieved (3 connections found)
    Updating peer information on interfaces
    Local interface gi2 linked to remote interface host1.domain.com:eth0
    Local interface gi10 linked to remote interface host2.domain.com:eth1
    Local interface gi3 linked to remote interface host3.domain.com:eth0
    Link layer topology processed
    Finished topology poll for node switch.domain.com
    **** Poll completed successfully ****

Can I send you the output of snmpwalk by mail?

]]>https://forum.netxms.org/post/12491https://forum.netxms.org/post/12491Fri, 17 Jan 2014 15:29:34 GMT<![CDATA[Reply to CISCO SMB Switch driver on Fri, 17 Jan 2014 14:59:06 GMT]]>Hi!

Most of the functionality should work out of the box. Driver is needed to provide VLAN information and picture of physical ports. Ideally would be to get output of full SNMP walk (starting .1).

Best regards,
Victor

]]>https://forum.netxms.org/post/12490https://forum.netxms.org/post/12490Fri, 17 Jan 2014 14:59:06 GMT