<![CDATA[Use ifTable instead of ifXTable?]]>I have a few less advanced (but dirt cheap) managed switches that do not have ifXTable, but do present info over ifTable.
Is there any way to fall-back interface discovery to use ifTable instead of ifXTable if the device only supports ifTable?

Currently, NetXMS doesnt show any interfaces on the switch, so I cant monitor port state.
SNMPWalking the device however, I can see all ports, they status and all required info in the ifTable.

]]>https://forum.netxms.org/topic/3327/use-iftable-instead-of-ifxtableRSS for NodeFri, 13 Nov 2026 06:23:10 GMTSat, 16 Aug 2014 21:32:35 GMT60<![CDATA[Reply to Use ifTable instead of ifXTable? on Wed, 20 Aug 2014 17:36:31 GMT]]>Hi,

NetXMS should fall back to ifTable automatically if ifXTable is not supported. You can forcibly disable by setting "Use ifXTable for interface polling" to "Disable" on "Polling" page in node properties.

Best regards,
Victor

]]>https://forum.netxms.org/post/14758https://forum.netxms.org/post/14758Wed, 20 Aug 2014 17:36:31 GMT<![CDATA[Reply to Use ifTable instead of ifXTable? on Wed, 20 Aug 2014 09:14:35 GMT]]>Anyone can share any info on this?

Thanks!

]]>https://forum.netxms.org/post/14744https://forum.netxms.org/post/14744Wed, 20 Aug 2014 09:14:35 GMT