<![CDATA[Transformation not working]]>Two DCI'S

net.interface.bytesin(65539)  :  Incoming traffic , this value is in bytes
net.interface.speed(LAN)        :  Total interface speed,  this number is in bytes (converted it from bits to bytes successfully)

I want the incoming traffic DCI to display the network load procentually instead of showing the bytes.

The transformation on incoming traffic DCI is as followed:
$1 / GetDCIValue($node, FindDCIByName($node, "Net.Interface.Speed(LAN)")) * 100

This transformation doesn't work, it just gives me an output of "0"

What am I doing wrong?

]]>https://forum.netxms.org/topic/376/transformation-not-workingRSS for NodeFri, 13 Nov 2026 08:36:33 GMTFri, 30 May 2008 10:04:16 GMT60<![CDATA[Reply to Transformation not working on Fri, 30 May 2008 13:52:21 GMT]]>Yes, that works fine.

]]>https://forum.netxms.org/post/1818https://forum.netxms.org/post/1818Fri, 30 May 2008 13:52:21 GMT<![CDATA[Reply to Transformation not working on Fri, 30 May 2008 11:54:17 GMT]]>If you remove transformation script from net.interface.bytesin(65539) parameter, did you get correct non-zero values?

Best regards,
Victor

]]>https://forum.netxms.org/post/1817https://forum.netxms.org/post/1817Fri, 30 May 2008 11:54:17 GMT