<![CDATA[Overrode network driver...now what?]]>With Cisco SB "SG550XG-8F8T 16-Port 10G Stackable Managed Switch" [OID .1.3.6.1.4.1.9.6.1.90.16.9] the automatically selected network driver is GENERIC. Everything seems to work OK except the Ports tab which is empty. System consists of a pair of these in a stack.

Followed instructions at https://www.netxms.org/forum/general-support/network-driver-type-incorrect/msg19491/#msg19491 to change driver to CISCO-SB. Ports tab is now populated but shows all ports in "Slot 1". The Components tab looks good - shows each stack member with one "slot" [these aren't modular switches] per stack.
I am not sure if the appearance of the Ports tab is what is expected in a stacked switch.
Assuming that the CISCO-SB driver is correct for this switch, what is required to get this type of device always to be detected as CISCO-SB?

]]>https://forum.netxms.org/topic/5150/overrode-network-driver...now-whatRSS for NodeFri, 13 Nov 2026 14:49:15 GMTWed, 12 Jul 2017 10:05:46 GMT60<![CDATA[Reply to Overrode network driver...now what? on Fri, 04 Aug 2017 09:29:54 GMT]]>Obviously I would rather send you the output of whatever snmpcommand you specify but if remote access is definitely what you need, PM me.

]]>https://forum.netxms.org/post/22843https://forum.netxms.org/post/22843Fri, 04 Aug 2017 09:29:54 GMT<![CDATA[Reply to Overrode network driver...now what? on Thu, 20 Jul 2017 07:49:24 GMT]]>Hi,

it seems that driver cannot handle stacked switches correctly. Is it possible to organize remote SNMP access  to such stack so we can debug and fix driver?

Best regards,
Victor

]]>https://forum.netxms.org/post/22732https://forum.netxms.org/post/22732Thu, 20 Jul 2017 07:49:24 GMT