<![CDATA[can't import Cambium epmp 3.5 mibs]]>hello, I'm trying to import cambiums but no luck.
below is the error message, and attached is the original MIB file.  I renamed it while trying to import it. nothing else has been edited.  not sure what else to do. any advice?

Thanks!

C:\NetXMS\bin>nxmibc.exe -d c:\NetXMS\swap
NetXMS MIB Compiler  Version 2.1.2 (2.1.2)
Copyright (c) 2005-2017 Raden Solutions

Parsing source files:
  c:\NetXMS\swap\35.txt
Resolving imports:
  CAMBIUM-PMP80211-MIB
CAMBIUM-PMP80211-MIB: ERROR 002: Import module "SNMPv2-SMI" unresolved

C:\NetXMS\bin>

CAMBIUM-ePMP-3.5-MIB.txt

]]>https://forum.netxms.org/topic/5329/can-t-import-cambium-epmp-3.5-mibsRSS for NodeFri, 13 Nov 2026 07:30:39 GMTFri, 17 Nov 2017 03:15:46 GMT60<![CDATA[Reply to can't import Cambium epmp 3.5 mibs on Wed, 22 Nov 2017 00:12:44 GMT]]>I didn't provide a destination file, once i did this it was successful.

Thanks!

]]>https://forum.netxms.org/post/23411https://forum.netxms.org/post/23411Wed, 22 Nov 2017 00:12:44 GMT<![CDATA[Reply to can't import Cambium epmp 3.5 mibs on Tue, 21 Nov 2017 23:56:43 GMT]]>I'm not sure if I followed what you meant by that.

I copied the MIB into the share/mib directory and tried to import it from there, where the rest of the mibs are and I get " error 002: Import module "SNMPv2-SMI" unresolved"

the command C:\NetXMS\bin>nxmibc  -d -z c:\NetXMS\share\mibs\CAMBIUM-ePMP-3.5-MIB.txt    i'm only trying to add 1 file.

screen copy and paste:

C:\NetXMS\bin>nxmibc  -d -z c:\NetXMS\share\mibs\CAMBIUM-ePMP-3.5-MIB.txt
NetXMS MIB Compiler  Version 2.1.2 (2.1.2)
Copyright (c) 2005-2017 Raden Solutions

Parsing source files:
  c:\NetXMS\share\mibs\CAMBIUM-ePMP-3.5-MIB.txt
Resolving imports:
  CAMBIUM-PMP80211-MIB
CAMBIUM-PMP80211-MIB: ERROR 002: Import module "SNMPv2-SMI" unresolved

]]>https://forum.netxms.org/post/23410https://forum.netxms.org/post/23410Tue, 21 Nov 2017 23:56:43 GMT<![CDATA[Reply to can't import Cambium epmp 3.5 mibs on Fri, 17 Nov 2017 06:09:46 GMT]]>Hi,

you should compile new MIB file together with the rest of MIBs. Either place it in same directory or specify multiple -d entries.

Best regards,
Victor

]]>https://forum.netxms.org/post/23392https://forum.netxms.org/post/23392Fri, 17 Nov 2017 06:09:46 GMT