<![CDATA[OID UNSUPPORTED]]>Hi Team,

In an installation im using MOXA branded switches, as a default NetXMS MIB browser doesn't have the OIDs for the mentioned brand. So I followed the steps mentioned in the 'Add MIBs' in the discussion forum and compiled the MIB file and now I could able to select the OIDs for the particular switch.

However I face the difficulty while adding the OID's to the DCI. When I select some OID's I could able to see the value in 'Walk" but when I add it to the DCI the NetXMS popup an error as "UNSUPPORTED"

I'm using MOXA- IKS 6726 A and EDS-408A switches and I have attached the screen shot

Regards
Ramesh

2018-06-08 12_29_55-NetXMS Management Console - admin@10.0.0.150.png

]]>https://forum.netxms.org/topic/5604/oid-unsupportedRSS for NodeFri, 13 Nov 2026 13:46:22 GMTFri, 08 Jun 2018 04:32:28 GMT60<![CDATA[Reply to OID UNSUPPORTED on Tue, 12 Jun 2018 01:44:47 GMT]]>in the walk result window im unable to right click

]]>https://forum.netxms.org/post/24408https://forum.netxms.org/post/24408Tue, 12 Jun 2018 01:44:47 GMT<![CDATA[Reply to OID UNSUPPORTED on Mon, 11 Jun 2018 09:16:57 GMT]]>Just a hint - to simplify DCI creation from OIDs and avoid mistakes, you can right-click on walk result and select "Create DCI".

Best regards,
Victor

]]>https://forum.netxms.org/post/24404https://forum.netxms.org/post/24404Mon, 11 Jun 2018 09:16:57 GMT<![CDATA[Reply to OID UNSUPPORTED on Mon, 11 Jun 2018 03:24:41 GMT]]>Hi Tursiops,

Thank you for your help, its working

Regards
Ramesh

]]>https://forum.netxms.org/post/24396https://forum.netxms.org/post/24396Mon, 11 Jun 2018 03:24:41 GMT<![CDATA[Reply to OID UNSUPPORTED on Fri, 08 Jun 2018 05:25:24 GMT]]>Hi,

If you have a closer look at your screenshot, you will notice that the OID in the walk which is holding the data is .1.3.6.1.4.1.8691.7.7.1.16.5.2.9**.0**.
The parameter you are trying to poll in your DCI is .1.3.6.1.4.1.8691.7.7.1.16.5.2.9, which is not the same thing and doesn't hold any data, hence you are getting unsupported as a result.
Add the .0 at the end of your DCI parameter and you should be good to go.

Cheers

]]>https://forum.netxms.org/post/24391https://forum.netxms.org/post/24391Fri, 08 Jun 2018 05:25:24 GMT