<![CDATA[Automated alarm termination]]>When a node goes down, I get an alarm in the alarm browser.  When the node comes back up I get a Node up alarm in the alarm browser.  What I need is:
When the node up alarm arrives, I need the node down alarm to removed from the active alarms and the node up alarm to stay for 60 seconds, then be removed.  Is this possible?

]]>https://forum.netxms.org/topic/6876/automated-alarm-terminationRSS for NodeFri, 13 Nov 2026 07:30:15 GMTThu, 21 Jan 2021 15:54:46 GMT60<![CDATA[Reply to Automated alarm termination on Thu, 21 Jan 2021 20:24:19 GMT]]>Very Limited Knowledge here - but I was doing Similar adjustments Yesterday (although not time)

Configuarion - Event Processing Policy (in the Desktop Client) - Appears there is an Alarm timeout option under "Action - Alarm" - so if you find the right event being triggered, you should be able to set.  You may need to run these changes as system also - i really don't know yet (also, don't forget to save after the change)

Again, very fresh here - so backup and note changes - so you can revert if required...

Good Luck

]]>https://forum.netxms.org/post/29333https://forum.netxms.org/post/29333Thu, 21 Jan 2021 20:24:19 GMT