<![CDATA[SNMP OID Fault Management]]>Hi,

I would like to configure some "data collection" on specific OID, to get router and switch major fault.I don't need to graph data, but only to get fault and error alarms.

Is it possible ? Which are the most common standard OID to get fault on network device?

Thanks.
Maggio

]]>https://forum.netxms.org/topic/911/snmp-oid-fault-managementRSS for NodeFri, 13 Nov 2026 13:21:35 GMTMon, 03 May 2010 10:41:24 GMT60<![CDATA[Reply to SNMP OID Fault Management on Wed, 05 May 2010 09:37:17 GMT]]>OK.Thanks.

]]>https://forum.netxms.org/post/4200https://forum.netxms.org/post/4200Wed, 05 May 2010 09:37:17 GMT<![CDATA[Reply to SNMP OID Fault Management on Tue, 04 May 2010 17:28:50 GMT]]>Hi!

There are no single standard "fault" OID. Usually, there are some vendor-specific OIDs from where you can get CPU utilization, memory usage, etc. and set your own thresholds. There are also standard OIDs for network interface errors. Also, you can setup SNMP trap processing, but again, it will be vendor-specific.

Best regards,
Victor

]]>https://forum.netxms.org/post/4189https://forum.netxms.org/post/4189Tue, 04 May 2010 17:28:50 GMT