CISCO SMB Switch driver
-
-
Hi!
Most of the functionality should work out of the box. Driver is needed to provide VLAN information and picture of physical ports. Ideally would be to get output of full SNMP walk (starting .1).
Best regards,
Victor -
Ok I short list what I get at the moment from such a switch (Cisco SG300):
'Show VLANs': ok
'Layer2 Topology': empty (only Switch itself)
Tools - Info - Topology Table (CDP): empty
Tools - Info - Topology Table (LLDP): empty
Tools - Info - Switch forwarding database: ok
Object Details - Ports: empty
Object Details - Interfaces: ok
Capabilities: isBridge, isCDP, isLLDP, isSNMP, isSTP, hasEntityMIB, hasifXTable
Poll - Topology:
VLAN list successfully retrieved from node
Switch forwarding database retrieved
Link layer topology retrieved (3 connections found)
Updating peer information on interfaces
Local interface gi2 linked to remote interface host1.domain.com:eth0
Local interface gi10 linked to remote interface host2.domain.com:eth1
Local interface gi3 linked to remote interface host3.domain.com:eth0
Link layer topology processed
Finished topology poll for node switch.domain.com
**** Poll completed successfully ****Can I send you the output of snmpwalk by mail?
-
So basically almost everything is working. CDP may be empty if nobody in the network sends CDP packets except that switch.
Yes, you can send dump by mail.
Best regards,
Victor
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login