Show IP in dashboard

[Djago]

Newbie here... don't shoot! 

I want to monitor my lousy TP-Link TL-R480T+ multiband router. I have 2 wan and sometimes one of them releases it public IP and goes to 0.0.0.0. So I created an alert. But I also want to show both WAN IPs on the dashboard. I can see the IP in the overview of the interface, but I don't know how to READ it.
How can I do this?

[Djago]

Anyone?

[duanebutler]

Working with dynamic public IP's I found it best to setup SNMP traps on the device in question.

I did the exact same setup on fortigate 80c that sends traps if the IP changed on the interfaces selected.

However it depends on SNMP on the device in question.

[Djago]

TP-Link doesn't like SNMP. Documentation is scarse and bad. So it's very difficult to read most parameters. That's why I'm hoping to use the parameters I CAN read...

[victor]

Hi,

you mean you see IP in interface overview in NetXMS UI? Then you can use script to get it into your message/DCI/etc. Function GetInterfaceObject can give you Interface object, which contains list of IP addresses.

Best regards,
Victor

[Djago]

Thanks

I've changed my old router. Now I have a MikroTik. I'll try first with SNMP.

Regards,
FSO