NetXMS Forum

Yes, I think you are right - if it's SYS_NODE_UNREACHABLE, then alarm is not created and timers are not set.  Actually SYS_NODE_UP event has parameter at index 1 which is set to 1 if node is returning from "unreachable" state and 0 if from "down", so you can filter by that in your recovery EPP rule by the following script: return $event.getParameter("reason") != 1;

Hello, yes the timer was running. Probably I found an issue, I had same name of timers and first policy canceled the timer so the second one sent email. Dumb error. Thank you:)

Great, thanks for the update

Hi Yes, it's supported. You need to install new packages, then run "nxdbmgr upgrade". Don't forget to backup first. Error is quite unexpected, but to be honest - we never tried such jump with packages. Which distro and version you are running? You can upgrade this way: mkdir ~/nx-backup cp -R /etc/netxmsd.conf /etc/nxagentd.conf /var/lib/netxms ~/nx-backup systemctl stop netxms-server nxdbmgr check apt-get --purge netxms\* apt-get install netxms-server netxms-dbdrv-pgsql # select correct DB driver, additional packages if needed systemctl stop netxms-server cp ~/nx-backup/nxagentd.conf ~/nx-backup/netxmsd.conf /etc/ nxdbmgr upgrade nxdbmgr check systemctl enable --now netxms-server

Hi, what Debian version you are using? Did you install server from packages? If possible, please run server under gdb and provide stack trace after crash. Best regards, Victor

Hi, please try to set debug level to 6 and check server log for lines with "SMTP" and "Sending mail" in it. Best regards, Victor

Ok I solved it I have to change also table charset and fields name charset. Thank you.

Hello, thank you. I upgraded our netXMS instance without any problems

Hi, NetXMS always use address given in "primary host name" field in node communication properties. Just change it to address you want server to connect to. Best regards, Victor

Ok, I solved it by: return real(GetDCIValueByDescription..... and also by val1 = real(GetDCI ...

Ok, I solved it by script: sub main() { val1 = GetDCIValueByDescription($node, "Used physical memory"); val2 = GetDCIValueByDescription($node, "Physical memory used for buffers"); val3 = GetDCIValueByDescription($node, "Physical memory used for cache"); return val1 - val2 - val3; }

Only to map, I will try to add also devices. Will let you know, thanks Edit: Yes, that was the problem. Thank you.

It works pretty well. Thank you sir

Ok, thank you