Retrieve Mikrotik Wireless Registration Table by SNMP

[andrey--k]

Can you provide output

$ nxadm -c " sh po " | grep -v 'wait'

5 seconds is wery small interval I think.

[dmartl]

Hi!,

Output of command is:

PT  TIME                   STATE

i think that it means that there isn't any probe on wait state, isn't it?

So, i will modify probe interval and set it to 120 sec to test and tell you soon.

thank you for your fast response!

[andrey--k]

That means that all probes in wait state.
You have no active probes at the moment...

[dmartl]

Hi again,

SNMP Table stills blank.

what can i do?

[andrey--k]

Try to make configuration and status poll on node via nxmc.

[dmartl]

using nxmc do you mean using windows app? if answer is yes, i'm configuring it by nxmc now. i don't know other way to add a node to netxms.

regards

[victor]

Hi!

All steps you do are correct. Can you please post screenshot of your table configuration? Also, is it possible to provide me with SNMP access to some test Mikrotik device so I can test if there are any bug withing NetXMS?

Best regards,
Victor

[dmartl]

Hi,

We are going to create a lab with one ap and two clients, asign a public ip address an send all data to you soon.

Thank you.

[dmartl]

Hi Victor,

I send you a private message with all data you need to get access to the lab.

Thank you.

[alk]

Note about Mikrotik support — it's already implemented and will be included in upcoming 1.2.14

[victor]

I just realize that SNMP table was not working because you have to provide one of table OIDs to collect instances. If you change table OID to .1.3.6.1.4.1.14988.1.1.1.2.1 it should work. It is not very convenient nor straight forward, I know SNMP tables definitely need improvement.

Best regards,
Victor

[dmartl]

@dmartl said in Retrieve Mikrotik Wireless Registration Table by SNMP:

Hi Victor,

I send you a private message with all data you need to get access to the lab.

Thank you.

Cooool!!!

I downloaded new version and it works like a charm. The driver apears to be a very earlier version, because in wireless clients doesn't show wireless strenght, ccq, and other values that mikrotik provides in registration table.

So, i'll try to modify driver source to add this values. if i have any improvement, i'll post here.

Thank you very much.

[aeixea]

Hello:

I have the same problem, have a registration table completelly blank... but my  <nxadm -c "sh po" | grep -v 'wait'> commnad, tell's:

PT  TIME                  STATE
A  30/Oct/2015 11:37:39  check

What is the key columnt in the table? I have mark iface and addrs (.1 and .2).

Thnx.