Hi,
We have 2 switches of the HP ProCurve series in our network. They were both discovered through snmp at initial discover.
In the object browser, both of them are called ""ProCurve Switch 2810-24G". I checked the config of these switches and gave them correct hostnames.
Then I did a configuration poll to the host, with the following output:
[21-May-2008 07:45:11] Sending poll request to server...
[21-May-2008 07:45:11] Poll request accepted
[21-May-2008 07:45:11] Starting configuration poll for node ProCurve Switch 2810-24G
[21-May-2008 07:45:11] Checking node's capabilities...
[21-May-2008 07:45:11] SNMP agent is active (version 2c)
[21-May-2008 07:45:12] System description changed to ProCurve J9021A Switch 2810-24G, revision N.11.06, ROM N.10.01 (/sw/code/build/bass(bh2))
[21-May-2008 07:45:13] Capability check finished
Checking interface configuration...
[21-May-2008 07:45:13] Interface configuration check finished
[21-May-2008 07:45:13] Checking node name
[21-May-2008 07:45:13] Node name is OK
[21-May-2008 07:45:13] Finished configuration poll for node ProCurve Switch 2810-24G
Node configuration was changed after poll
[21-May-2008 07:45:13] Poll completed successfully
The device name should be siebru001n, as seen here:
Siebru001n 21-May-2008 7:47:41
===========================- TELNET - MANAGER MODE -============================
Switch Configuration - System Information
System Name : Siebru001n
System Contact :
System Location : 5161/1
Inactivity Timeout (min) [0] : 0 MAC Age Time (sec) [300] : 300
Inbound Telnet Enabled [Yes] : Yes Web Agent Enabled [Yes] : Yes
Time Sync Method [None] : None
What I am doing wrong?
Greetings
Tom
